Winch Swap Day!

Major Upgrade Day!




I finally got around to installing my bargain bin Warn Zeon 10-S winch that I got for half price because it was "non-functioning." New controller and BAM fully operational!


The bumper isn't designed to accept this winch, so I had to make some 1-1/4" spacers for the foot mount to get the winch to clear the taper of the bumper.



I finished it off with a Factor55 Ultrahook and RRP.



The controller pack is zipped to the bumper for now while I figure out a mounting solution for it. I'll be cutting the roller fairlead mounts off and making a front license plate holder to cover the top line feed opening.

Comments

Post a Comment

Popular posts from this blog

Image
 Installed the sPOD and Probably Saved my 80 and my Life! I finally got around to completing the installation of my sPOD BantamX and got all the aux lights and aftermarket devices wired up. What I found under the dash was a bit startling though. Most of the wires the previous owner had run were too small for the loads they carried and were melted and burned. There were probably four aftermarket stereo installs stacked on top of one another that I still need to complete removal. What a mess!
Read more

Light'em Up!

Image
 Stereo Redux 2.0... (There will be a 3.0) & Replacing Bulbs The PO (I think two POs ago) did a number on the stereo he installed. House speaker wire, power, ground, and accessory power wired apart from the factory harness and the factory amp gutted. He left a rat's nest of wires behind the dash as well as cutting out all the supports and just setting an aftermarket stereo in the hole. It took me a while to sort things out, get the joints soldered and everything to fit. It isn't where I want it to be, but it is better than it was. I decided to ignore the factory harness, and wire up a new one too. 3.0 will involve new speakers, new amp, new speaker wire and I'll connect all of it to the factory harness to keep things clean. I got the dimmer working! Installed new bulbs in the dash to improve visibility and get all the indicators working. I got all the switches and aux audio & power ports installed. I also shot the bezel with textured black topcoat so I could delete ...
Read more

It is Good to Have Fabrication Friends

Image
 Mounts, mounts, and more Mounts! I took Yagi to my buddy Ryan's house to get some mounts fabricated. Three out of four were completed because I need to do some rearranging in the engine compartment for the compressor to fit. sPOD and UDA module Hi-Lift mount I need to pull the boat battery left by the PO and install a smaller blue top Optima in a box and possibly replace the factory coolant overflow and windshield washer bottles to fit the ARB twin compressor. 
Read more